Fuguang

Hotline:400-668-8627

搜索

语言切换

语言切换

Time of issue:2020-04-29 00:00:00
1 1
Your location:
Homepage
/
8362sc pH analyzer for high purity water

Controllers and sensors

Controllers And Sensors

ORP探头

8362sc pH analyzer for high purity water

-Typical application is suitable for online monitoring of pH value of high-purity water-Working principle Inside the measurement probe of the SOLITAXTMsc turbidity / suspended substance online analyzer, there is a built-in LED light source at a 45 ° angle, which can emit 880nm near infrared light to the sample After the scattered particles in the sample are scattered, the scattered light at an angle of 90 ° to the incident light is detected by the detector in this aspect and calculated to obtain the turbidity of the sample. When measuring the sludge concentration, the scattered light at an angle of 140 ° to the incident light is detected by the rear detector in this direction, and then the suspended matter online analyzer passes the calculation before
ORP探头
Product description
Technical indicators
- typical application
 
Suitable for online monitoring of high-purity water pH
 
 
 
- working principle
 
Inside the measurement probe of the SOLITAXTM sc turbidity / suspended substance online analyzer, there is a built-in LED light source at an angle of 45 °, which can emit near infrared light at 880nm to the sample. The scattered light with an angle of 90 ° is detected by the detector in this aspect and is calculated to obtain the turbidity of the sample. When measuring the sludge concentration, the scattered light at an angle of 140 ° to the incident light is detected by the rear detector in this direction, and then the suspended solids online analyzer calculates the signal strength detected by the front and rear detectors to give the pollution Mud concentration value.
 
Because the LED emits near-infrared light at 880nm, if there is color in the sample, it will not affect the measurement result.
 
 
 
-Instrument characteristics
 
● On the detection board, including flowmeter, flow cell, PH electrode, temperature electrode
 
● Low flow requirements-good representativeness of samples
 
● High-precision temperature compensation system
 
● Automatic boost pressure reference electrode-long-term stability, no maintenance required
 
● The flow cell is also used as a calibration cup-no other facilities are required
 
● All materials are stainless steel or special conductive plastic-corrosion-resistant, fully grounded system
 
● The sensor quick connector is plug and play
 
● Transparent flow cell-easy to observe
发送反馈
历史记录
Scan the QR code to read on your phone
We could not find any corresponding parameters, please add them to the properties table
Technical index
Measuring range: 2~12pH; -1500 ~ +1500 mV;
Sample temperature: 0~ 80℃
Accuracy: ± 0.05 pH ± 3 mV (conductivity higher than 1μS / cm at 25 ℃, stable flow)
± 0.1 pH: ± 3 mV (25 ° C conductivity is less than 1μS / cm, the flow rate is stable)
Repeatability: 0.01 pH;25 ℃
Temperature accuracy: 0.1 ℃ between 0-80 ℃
Ambient temperature: 0-60℃
environment humidity: 0-100%, non-condensing
Sample flow: 100-300 mL/min
Sample pressure: 4bar( 25 ℃)

 

Copyright ©2020 Fuzhou Fuguang Water Science&Technology    闽ICP备12013341号-2 

Fuzhou Fuguang Water Science&Technology Co.,Ltd

闽ICP备12013341号-2 

 Powered by www.300.cn